Skip to main content

POTTING AND MOLDING ELECTRICAL CABLE ASSEMBLY TERMINATIONS, STANDARD FOR

Options for Standards Update Notification System (SUNS)
Send SUNS Updates
Yes
SUNS Notification Type
Revision
Organization that Developed the Standard
Organization that Developed the Standard
NASA Standard
Document Identifiers
Document Number
KSC-STD-132
Version
E
Document Date
Change Date
Is Active?
ACTIVE
NASA Organization and Technical Discipline
Responsible NASA Organization
KSC - Kennedy Space Center
Endorsed Standard
Endorsement Details
Endorsing NASA Organization
OCE Endorsed Standard
NASA Core Standard
No
Mandatory Standard
NASA Mandatory Standard
Not a NASA Mandatory Standard
Document Scope
Document Scope
The purpose of this document is to establish a standard process for potting and molding electrical cable assembly terminations using epoxy-resin potting compositions and elastomeric dielectric compounds.
This standard describes the materials and methods to be used in potting and molding electrical cable assembly terminations with epoxy-resin potting compositions and elastomeric dielectric compounds and describes the facilities and equipment required to perform the potting and molding processes. The standard dimensional requirements for molding specific types of cable assemblies are specified in 120E0600001, KT02415, and Appendix A. Appendix B is a Guideline for Fabricating Molds Used with Elastomeric Compounds to Mold Electrical Connectors and Cable Sheaths.
Document Access Control
Document Viewable by
Export Control/Distribution Authorization
Internet Public -- Standard is cleared for public accessibility on the internet.
PUBLIC: Upload Publicly Available Standard
KSC-STD-132-Rev-E-06-28-2023-Final-002.pdf (820.87 KB)
PUBLIC: Document History for Standard
KSC-STD-132-Rev-D-Chg-3.pdf (3.12 MB)
KSC-STD-132-Rev-D-Chg-4.pdf (3.44 MB)
Submitted Date

 

Application Notes for this Standard

-No Application Notes are associated with this standard.

Lessons Learned Related to this Standard

To associate Lessons Learned to a specific standard, find the related lesson in LLIS. These lessons have been vetted and approved via the lessons learned process. Then, click “Create a new “Lessons Learned” record for this Standard” and complete the information.

If you have a lesson learned that is not in LLIS, click “Proceed to the NASA Engineering Network to create a new “Lesson Learned” about this Standard” to be vetted and approved in that process. Then, associate the lesson by clicking “Create a new “Lessons Learned” record for this Standard.”


-No Lessons Learned are associated with this standard.