Skip to main content

HEAT AND BLAST PROTECTION COATING MATERIALS AND APPLICATION METHODS, SPECIFICATION FOR

Options for Standards Update Notification System (SUNS)
Send SUNS Updates
Yes
SUNS Notification Type
Revision
Organization that Developed the Standard
Organization that Developed the Standard
NASA Standard
Document Identifiers
Document Number
KSC-SPEC-F-0006
Version
C
Change Number
0
Document Date
Is Active?
ACTIVE
NASA Organization and Technical Discipline
Responsible NASA Organization
KSC - Kennedy Space Center
Endorsed Standard
Endorsement Details
Endorsing NASA Organization
OCE Endorsed Standard
NASA Core Standard
No
Mandatory Standard
NASA Mandatory Standard
Not a NASA Mandatory Standard
Document Scope
Document Scope
This specification is mandatory for use at the Kennedy Space Center (KSC) and other areas where KSC has jurisdiction. This specification is applicable to NASA Civil Servants and NASA contractors (including subcontractors, service providers, and construction contractors). This specification establishes requirements for ablative coating materials for launch structures and ground support equipment (GSE). Ablative coatings are most commonly, but not limited to, the use as a sacrificial coating to protect underlying GSE from direct or indirect impingement of the heat flux and/or particulates from launch vehicle exhaust.
Document Access Control
Document Viewable by
Export Control/Distribution Authorization
Internet Public -- Standard is cleared for public accessibility on the internet.
PUBLIC: Upload Publicly Available Standard
KSC-SPEC-F-0006_RevC_Final.pdf (456.18 KB)
PUBLIC: Document History for Standard
ksc-spec-f-0006b-old-version.pdf (1.25 MB)
Submitted Date

 

Application Notes for this Standard

-No Application Notes are associated with this standard.

Lessons Learned Related to this Standard

To associate Lessons Learned to a specific standard, find the related lesson in LLIS. These lessons have been vetted and approved via the lessons learned process. Then, click “Create a new “Lessons Learned” record for this Standard” and complete the information.

If you have a lesson learned that is not in LLIS, click “Proceed to the NASA Engineering Network to create a new “Lesson Learned” about this Standard” to be vetted and approved in that process. Then, associate the lesson by clicking “Create a new “Lessons Learned” record for this Standard.”


-No Lessons Learned are associated with this standard.