Skip to main content

JSC FABRICATION TOLERANCES AND PRACTICES

Options for Standards Update Notification System (SUNS)
Send SUNS Updates
No
SUNS Notification Type
New Standard
Organization that Developed the Standard
Organization that Developed the Standard
NASA Standard
Document Identifiers
Document Number
JSC-67701 DCN 001
Version
Baseline
Change Number
0
Document Date
Change Date
Is Active?
ACTIVE
NASA Organization and Technical Discipline
Responsible NASA Organization
JSC - Johnson Space Center
Endorsed Standard
Endorsement Details
NASA Core Standard
No
NASA Endorsed Standard Status
Not NASA Endorsed
Mandatory Standard
NASA Mandatory Standard
Not a NASA Mandatory Standard
Document Scope
Document Scope
When this document is referenced, the tolerances and limits herein are the maximum permissible for applicable, un-toleranced dimensions shown on the drawing, and unless otherwise specified, the practices herein are required where applicable. Note: The phrase “unless otherwise specified” applies to all sections of this document.
Keywords
fabrication, tolerances
Document Access Control
Document Viewable by
Export Control/Distribution Authorization
Internet Public -- Standard is cleared for public accessibility on the internet.
PUBLIC: Upload Publicly Available Standard
JSC-67701_JSC_Fabrication_Tolerances_and_Practices_Basic_DCN001_Final.pdf (1.17 MB)
Important Standard Dates
Next 5-Year Review Date
Submitted Date

 

Application Notes for this Standard

-No Application Notes are associated with this standard.

Lessons Learned Related to this Standard

To associate Lessons Learned to a specific standard, find the related lesson in LLIS. These lessons have been vetted and approved via the lessons learned process. Then, click “Create a new “Lessons Learned” record for this Standard” and complete the information.

If you have a lesson learned that is not in LLIS, click “Proceed to the NASA Engineering Network to create a new “Lesson Learned” about this Standard” to be vetted and approved in that process. Then, associate the lesson by clicking “Create a new “Lessons Learned” record for this Standard.”


-No Lessons Learned are associated with this standard.